|
Re: Help...unknown drop method?
Not sure what you have there with the what appears to be welding around the upper area, My stock spindles are taller between the ball joint mounts.
Those are not drop spindles, The wheel shaft is mounted too low on the spindle right next to the lower ball joint. Drop spindles will have the wheel shaft mounted higher on the spindle closer to center of the two ball joint mount areas.
http://67-72chevytrucks.com/vboard/s...d.php?t=462976
Regardless, If I seen that welded area appearance on my rig they'd come off pronto......
__________________
93 Jeep XJ
88 Buick La Sabra
Toys;
88 TA-GTA in the works....
97 GMC Ext. Cab
502 Crate 5 Spd......Sucks Gas But Haulz Azz ! 
The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic.
"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
Last edited by Restrorob; 05-14-2011 at 05:19 PM.
|