I must say the sliding jig is a success .... Check it out !!
-
-
-
-
The great thing about the slide, is that I can move it back and forth as I make cuts and trims to make everything fit perfect ....
-
Here, you can see the differences in the tunnel shapes ... Which will require a little shaping ...
-
-
-
Here, small slices on either side of the 'front' half to allow the flange to 'ride' up the rear plate....
-
-
Note how the sides come together evenly ...
-
-
-
-
Even the center has come together with the same bottom plate side lap...
-