|
Re: 82 front suspension on a 66 questions
Quote:
Originally Posted by munchieu
I found a 82 donor truck. I want to roll the 82 front end under the 66. crossmember and all. I heard to do this I need to make two holes larger and drill two fresh holes. After looking at the trucks I can see where it needs to be done. My question is what to do with the motor mounts? the 66 was a 6 cyl and will now be a 350. the motor mounts off the 82 do not fit the two top bolt holes of the 66 frame. Where do I go from here?
|
Did you try to re-use the mm's/towers that were w/the 66 x-member? You might just need to re-drill the holes in the x-member part??
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 05-30-2011 at 09:44 PM.
|