The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**kev2809** · 06-01-2011, 08:35 PM

good point lol..

i went and picked up some 1/4" scrap plate a buddy had laying around. this is going to be tough to try to line up...since i also have to drill out the bolt holes and air fitting hole.

is it possible to jack up the truck, remove the bags, jack up the axle all the way til the ta hits the frame, then align, level, and weld the bag mounts? or they HAVE to aligned during ride height?

i been lookin at this for about an hour trying to find the easiest way to do it..

06-01-2011, 08:35 PM	#10
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,193	Re: Bags over axle good point lol.. i went and picked up some 1/4" scrap plate a buddy had laying around. this is going to be tough to try to line up...since i also have to drill out the bolt holes and air fitting hole. is it possible to jack up the truck, remove the bags, jack up the axle all the way til the ta hits the frame, then align, level, and weld the bag mounts? or they HAVE to aligned during ride height? i been lookin at this for about an hour trying to find the easiest way to do it.. __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_]