Are your pistons designed for a 6" rod?
Scat does make a 5.7 I-beam rod specifically for a 'stroker' engine. You will still have to check the clearances, and grind accordingly.
I couldn't find a direct link, but the number is 25700P for the pressed pin or 25700 for the bushed pin.
Quote:
Originally Posted by 05Gibbs
http://www.competitionproducts.com/S...uctinfo/SCR6A/ what do u think of these? dont have a bunch of money to throw at a set of rods and im not sure if i can use h beams being that its a 383 because my elgin rods are clearanced a little so i figure the h beams would be too close
|