[West Texas Z]

Originally Posted by Goats86

Several ideas, did you just rebuild it? If so, the anchor pin on the band might have missed the hole in the band. If you had the valve apart, sometimes the valves stick even though you might have cleaned them well. When I put mine back together, it was the TV sticking. Pull the cable loose at the carb, and yank it quickly a few times, sometimes that will get it unstuck.

Originally Posted by 1LowToy

You may want to look this over http://www.rowand.net/shop/tech/auto...issionswap.htm

I'm planning that conversion but with an inline six. From what I gather the cable pressure curve is very sensitive to the operation of the tranny.

To answer a previous post, I have not rebuilt it, but i have added the following:

1. B&M shift improver kit
2. TCI lockup converter
3. possibly going to add a "corvette" servo
4. new fluid, filter, and gasket.
5. new TV cable


any thoughts??