|
Re: Steering Column assistance needed
Thank you so much LockDoc!
The lower bearing would not fit up inside the column because the ring that it fits into was upside down. I reversed it and it fits now. As long as I had it apart I put wheel bearing grease on the bearings. I'm just afraid of what else has been taken apart and put together wrong. Here are pictures of where I am now. My concern right now is that I'm not able to put the shifter through the motions. I don't know the right terminology but it seems that the shifter linkage is getting caught on each other and not allowing it to go to the park position. Can you look at these pictures and see if you see anything wrong? Or does it need the pressure from the steering wheel before it can go through the shifter motions?
|