I just realized that as well, but I did find a single 16" pusher rated at 3600cfm's so that might be the ticket. But I need to remeasure the rad support to be sure.
If I run a single pusher fan with a built in shroud would I still need a shroud on the other side? I would think not right?
Quote:
Originally Posted by 55metalmonkey
4000 cfm sounds good but the 28.5" wide might be an issue. if it is in front of the core support it might just give you a good mounting surface. a little over 3" thick too, be worth diging out the tape measure and checking out
|