The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Front end wobble after spindle U-bolt replacement and cut front springs?

Low & Slow · 07-08-2011, 11:47 PM

I was told that factory length front shocks would be fine and there is still plenty of travel in them. Problem still happens on flat roads as well.

I'm confussed because it rode perfectly fine two days ago so I feel like I did something. I tried searching and didn't really come up with anything.

The only thing I can logically think of is that the drive shaft is binding and shaking because of the new angle caused by the rake. Does that sound plausible?

Dammit I love this truck regardless!
Posted via Mobile Device

07-08-2011, 11:47 PM	#3
Low & Slow Registered User Join Date: May 2011 Location: Philly Pa Posts: 124	Re: Front end wobble after spindle U-bolt replacement and cut front springs? I was told that factory length front shocks would be fine and there is still plenty of travel in them. Problem still happens on flat roads as well. I'm confussed because it rode perfectly fine two days ago so I feel like I did something. I tried searching and didn't really come up with anything. The only thing I can logically think of is that the drive shaft is binding and shaking because of the new angle caused by the rake. Does that sound plausible? Dammit I love this truck regardless! Posted via Mobile Device