The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Front end wobble after spindle U-bolt replacement and cut front springs?

Low & Slow · 07-09-2011, 05:22 PM

Sooooooo crap. One coil dropped it down 3"?

Am I better off getting lowering springs or a factory set and cutting them half a coil this time? I cut the bump stops in half and they are clearing now. No wagging motion. It was the bump stops.

If it is clearing the bump stops now is it ok to drive?

07-09-2011, 05:22 PM	#17
Low & Slow Registered User Join Date: May 2011 Location: Philly Pa Posts: 124	Re: Front end wobble after spindle U-bolt replacement and cut front springs? Sooooooo crap. One coil dropped it down 3"? Am I better off getting lowering springs or a factory set and cutting them half a coil this time? I cut the bump stops in half and they are clearing now. No wagging motion. It was the bump stops. If it is clearing the bump stops now is it ok to drive?