The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

blkcorvair · 07-27-2011, 08:31 PM

Cleaned up the metal and test fit the floor. Does fit much better than I anticipated. Got no gap at the hump. The radius at the gas pedal is to shallow though and doesnt line up great. If I shave an 1/8" off the lip at the far right I think I can get it to sit far enough down to not upset me too much. Dont see the justice in making a bunch of relief cuts to make it 100% when its going to be covered with Floor matting later anyhow. Other than that I am so glad I chose to go the full floor route rather than a bunch of pieces. Going to look the part when its done now!

07-27-2011, 08:31 PM	#16
blkcorvair Registered User Join Date: May 2011 Location: Long Island NY Posts: 795	Re: 1969 Olive Stepper Cleaned up the metal and test fit the floor. Does fit much better than I anticipated. Got no gap at the hump. The radius at the gas pedal is to shallow though and doesnt line up great. If I shave an 1/8" off the lip at the far right I think I can get it to sit far enough down to not upset me too much. Dont see the justice in making a bunch of relief cuts to make it 100% when its going to be covered with Floor matting later anyhow. Other than that I am so glad I chose to go the full floor route rather than a bunch of pieces. Going to look the part when its done now!