The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

87 Shortwide · 08-07-2003, 03:00 PM

Hey gary, Actually I found a pretty simple way to work those out. For the lap belts, I just ran down and used the stock belt holes to mount them, you have to bend the bracketry a little if I remember right, but it all fits up good. as for the shoulder harness, buy the simpson 5-way harness mounting kit, its part no. 856-31020 from jegs and runs like $14.00. Just drill a hole behind the seat and run the eye bolt through, then you can have a removeable shoulder harness, because yes, they do get annoying to have in there at times.

Here is a pic of the harness mounting kit:

08-07-2003, 03:00 PM	#2
87 Shortwide Registered User Join Date: Nov 2002 Location: Wichita Ks Posts: 536	Hey gary, Actually I found a pretty simple way to work those out. For the lap belts, I just ran down and used the stock belt holes to mount them, you have to bend the bracketry a little if I remember right, but it all fits up good. as for the shoulder harness, buy the simpson 5-way harness mounting kit, its part no. 856-31020 from jegs and runs like $14.00. Just drill a hole behind the seat and run the eye bolt through, then you can have a removeable shoulder harness, because yes, they do get annoying to have in there at times. Here is a pic of the harness mounting kit: __________________ Daily Driver: 1992 Blazer dropped on rallys Project: 87 GMC shortwide, About to get a little boost