Thread: Door reassembly
View Single Post
Old 08-15-2011, 11:18 AM   #5
TDS-MN
Registered User
 
Join Date: Sep 2009
Location: Mpls, MN USA
Posts: 151
Re: Door reassembly

Quote:
Originally Posted by camshaftgsxr View Post
door locks and hardware then vent window with rubber attached the leaving the bolts out of the bottom of the window tracks, next put the regulator in, not bolted, just the crank through the hole. then attach the inside roller on the track on the door and then by cranking the window back and forth the other two rollers will slide right in, then crank it until the bolt holes line up and bolt it in. assuming you have manual windows.
This is th e sequence that worked for me! Although I had a regulator already in the door shell that I had purchased, so that COULD go in ahead of time.
__________________
TomS.
'98 S-10 Blazer 4dr 4wd - 4.3, AT, stock
&
'85 K-10 w/ 305, 700r4, np208, and RUST!
SOLD Dec 2014
TDS-MN is offline   Reply With Quote