The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Re-working stock engine harness

Juiced06GTO · 08-21-2011, 10:27 AM

I also used lt1 swap for my info. The current performance fuse block looks nice, i built my own using the info on lt1swap, but I don't think the current performance one was available when I did mine. I drive the truck everyday and have probably 10k miles on the swap so far. Also used it to plow my driveway this past winter and everything is still going good. The only thing giving me fits is rust creeping up on the body, the vss stopped getting a signal, and it desperately needs an OD (4.10's with a th400 and 3's means 3k rpm on the highway!) Use the site its great just take your time.

08-21-2011, 10:27 AM	#13
Juiced06GTO Registered User Join Date: Jul 2010 Location: Sutton, MA Posts: 130	Re: Re-working stock engine harness I also used lt1 swap for my info. The current performance fuse block looks nice, i built my own using the info on lt1swap, but I don't think the current performance one was available when I did mine. I drive the truck everyday and have probably 10k miles on the swap so far. Also used it to plow my driveway this past winter and everything is still going good. The only thing giving me fits is rust creeping up on the body, the vss stopped getting a signal, and it desperately needs an OD (4.10's with a th400 and 3's means 3k rpm on the highway!) Use the site its great just take your time.