Quote:
Originally Posted by Heavy87Chevy
http://67-72chevytrucks.com/vboard/s...d.php?t=474536
A while back I damaged my rear end, theres pics & details in that thread.. What I've learned since is that there was half of a gear floating around in my rear diff from the last time it was worked on (the previous owner) so it was just a matter of time before it broke some other things, maybe it was on the magnet all along & finally came loose, who knows.. I don't know how someone could make such a dumb mistake, but its done now.
I'm going to rebuild my rear end with new parts since I wasn't able to track down parts to do an easy swap. I was looking in LMC (just to see what all I need) & looking at axle shafts its saying that any 10 bolt with 8.5" ring gear will have 28 spline axle shafts, but when I took my axle shafts out, they were 30 spline. I'm really unsure as to what that means, & I want to make sure I order all the right parts.. I'm not going to replace the axle shafts, but I want to be sure when I get my side gears that they will be 30 spline. Can anybody provide me with some insight here?
|
You can get a newer ring & pinion set on a carrier with 30-spline spider gears pretty cheap at nearly any wrecking yard. The 88-up 1/2-ton Chevy & GMC trucks, Suburbans & Tahoes still use the same 8-1/2" 10-bolt guts that are in your rear axle.
My local yard has two sets right now with 3.73 gears on a posi carrier for $150. You should be able to find some locally for about the same.
You could also just go to a pull it yourself wrecking yard and grab the whole rear end out of an 88-up truck for under $100 and put the square body spring perches from your rear end onto it. They are just a little wider than the square body rear end and push the rear wheels outward a little to even out the inset rear wheels the square body trucks have. This way the front & rear wheels have closer to the same track width & wheel well location. You will probably not find a low mileage 88-up rear end in a pull it yourself wrecking yard so it will probably need new bearings at the least.
With the kind of damage you have the bearings are all compromised and need replaced any way so rebuilding your rear end or getting a newer one to rebuild will cost about the same money once you buy the repair parts yours needs.
Setting your pinion depth to get the right wear pattern, setting pinion bearing preload and setting ring gear backlash are not things to be taken lightly. Just the slightest error can ruin parts in a hurry and cost you way more than what a rear end shop will charge you to set up the gears properly the first time. If your friend hasn't specifically rebuilt GM rear axles before you are better off spending the money to have a shop do the setup for you. If you bring them the rear end and parts in hand most shops will only charge you $100 to $150 to install the bearings and set the gears up properly. Well worth the money.