[CC69Rat]

With the 73+ K member swap on my truck and McGaughys HD 2.5 front drop spindle and rotor kit - Do you think I might have added a little to the track width? The factory springs were also cut one turn by the PO. .. and the iron headed big block of course

I'm tempted to just get the same setup Keith has on the Stella truck. I need to do a notch anyway. My axle tube is pretty close now and I have at least 5 maybe 6" drop springs in it. I'll get some pictures of it this weekend.

I'm afraid my exhaust is going to be a big problem too .. Ex. If I go low enough to run the Stella Mae setup and make it look right I really need to go low enough for bags, causing other potential problems. I want to be able to drive it and not bottom out or bend the crap out of a wheel if I hit a pothole or something. That's why I was looking at the 20x8.5 for the rear.