UPDATE 9/4/11 - Fuel Lines. Been slowly collecting AN fittings, hose, and tubing to plumb the truck. Finally found some time to get the fuel lines run. I'm going with -8AN supply and -6AN return.
Bent some aluminum tubing down the length of the frame for the hard lines. Supported about every 13" - 14". Used padded tube clamps and made up some spaces to get them off the frame rail.
Mallory fuel filter. Short run of Aeroquip braided stainless from the tank.
Engine side. Need to make a small bracket that will attach to the top bolt of the water pump. It'll hold a tubing separator to keep the lines in place.
Tranny cooler and power steering lines are next when I can find time.