The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

oneperfectrun · 09-10-2011, 07:03 PM

Hi guys. New member here from north Ms. I didn't see a thread to introduce myself so I'm doing it here. Great forum by the way!

I did most of the disc conversion on my '70 chevy c10 today. New spindles and have the disc mounted. Ran out of time this afternoon when I was putting calipers in place. Are they marked as to which side they go on? I just assumed the bleeder valves would go to the top and stuck them on that way but not sure the brake lines a gonna be right in that position. Any ideas? Like I said I ran out of time and didn't get to look at them very close to see if they were marked.

Thanks,
Jeff
Posted via Mobile Device

09-10-2011, 07:03 PM	#1
oneperfectrun Registered User Join Date: Aug 2011 Location: Fulton, MS Posts: 87	Caliper placement on disc conversion? Hi guys. New member here from north Ms. I didn't see a thread to introduce myself so I'm doing it here. Great forum by the way! I did most of the disc conversion on my '70 chevy c10 today. New spindles and have the disc mounted. Ran out of time this afternoon when I was putting calipers in place. Are they marked as to which side they go on? I just assumed the bleeder valves would go to the top and stuck them on that way but not sure the brake lines a gonna be right in that position. Any ideas? Like I said I ran out of time and didn't get to look at them very close to see if they were marked. Thanks, Jeff Posted via Mobile Device