The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

punkavenger · 10-01-2011, 08:05 PM

Howdy

A quick question about timing ... Just adjusted the timing in my Apache 235 to where the BB is about 1/4" before the timing "needle" on the bell housing. No actual degree marks that I could see like on a V8. I figure if the needle is TDC then a little bit before would be approx. 10 degrees BTDC.

Is this correct? Runs good!

Thanks!

10-01-2011, 08:05 PM	#1
punkavenger Registered User Join Date: Sep 2011 Location: Seattle, WA Posts: 32	timing question 59 Apache 235 Howdy A quick question about timing ... Just adjusted the timing in my Apache 235 to where the BB is about 1/4" before the timing "needle" on the bell housing. No actual degree marks that I could see like on a V8. I figure if the needle is TDC then a little bit before would be approx. 10 degrees BTDC. Is this correct? Runs good! Thanks!