[85burb]

I have redone all 4 wheels with in 3 mounths. Pads, rotors, calipers, durms, hardware, shoes, cylinders, even cables. The only thing i did not replace is the hoses and master cylinder. What is this pin that you are supposed to install befor bleeding the breaks? Maybe i will try bleeding it.

If i understand the operation of the valve the light should only come on if i have pushed the breaks. Then the little valve or what ever will move and block off some passeges and set the light. When i start the truck befor i ever push the breaks the light is on. I can drive around and the light will go off. If i restart the truck sometimes the light will come back. To me that sounds more like an electrical problem then a issue with the breaks. I will try to bleed them tomorrow maybe and see if that helps. Just need to know what the pin is that is supposed to be used.