The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

56hotrodred · 10-19-2011, 11:30 PM

So I was just doing an engine flush as I now have my engine running and thought I would put it in gear and see how the clutch felt. Well it did not move although I thought I could hear the clutch engage!

MY QUESTION IS: With the NP 203 full time transfer case and no front drive shaft bolted up should it still move when put in gear?

Where else should I look if it should move without front driveshaft?

56hotrodred (Barry)

10-19-2011, 11:30 PM	#1
56hotrodred Registered User Join Date: Aug 2007 Location: Mountain View, Alberta, Canada Posts: 415	73 4x4 will not move? So I was just doing an engine flush as I now have my engine running and thought I would put it in gear and see how the clutch felt. Well it did not move although I thought I could hear the clutch engage! MY QUESTION IS: With the NP 203 full time transfer case and no front drive shaft bolted up should it still move when put in gear? Where else should I look if it should move without front driveshaft? 56hotrodred (Barry)