View Single Post
Old 08-20-2003, 08:51 AM   #11
Huck
Senior Member
 
Huck's Avatar
 
Join Date: Jun 2001
Location: Shelbyville, KY
Posts: 3,261
ONE MORE TIME~~~~~~~
loosen the 3 bolts on each hinge where it mounts to the fenders. Then have a friend push the hood up till you reach the end of the hinge travel---then push it up just a wee bit higher---then tighten those hinge bolts. Make sure you don't just close the hood without checking the front to rear alignment as this method does tend to move the hood back a bit but it will bring the rear of the hood down even with worn hinges. Make sure you lube the hinge pivot points and keep them lubed---I use white lithum greese. Good luck ---Huck
Huck is offline   Reply With Quote