Quote:
Originally Posted by Firebirdjones
I'm going to bend custom on mine. With a decent wall thickness you shouldn't have to worry about bending the tube, unless you're 400+ lbs and jump up and down on it  Especially if you use the same thing roll cages are made of. If it will support a roll over you should be able to stand on it.
I'm running mine to the frame, using flat plate and bolting in on the frame so I can remove it easily, and keeping it very close to the rocker panel for a clean and somewhat undetectable look. So it can also serve as a rocker panel protector (not necessarily a rock slider though) and also a step. I'm shooting for mine to only stick out about 6" past the rocker, just enough to get a foot on it. |
did you make any progress on that project?