View Single Post
Old 11-11-2011, 11:54 PM   #2
snacks
Registered User
 
snacks's Avatar
 
Join Date: Jan 2009
Location: rocklin california
Posts: 142
Re: Upper Control Arm Shaft - HELP

slide the rubbers on each side of the shaft, place the shaft in the controll arm and hand start both end caps to the point you need a tool, use an impact and tighten down each side a little at a time until they are flush up against the controll arm they will be tight after your done thats what you want.o and install grease fitttings fill with grase
snacks is offline   Reply With Quote