The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

blazerboy72 · 11-13-2011, 09:46 PM

Plans for my project has changed again. I have decided to go with a static drop, so I have 4-re7 bags front plates and cut cups with several fittings and some line. I also have decided I dont want e-brakes. I have a complete camaro disk brake setup i wont be using. It includes used calipers with cables glocks brackets, new pads and rotors. Non off these parts have any miles on them other than the calipers but they have been installed just sitting there so they may have surface rust but I can blast them if needed. Everything is still installed, I am going to try to pull it out this week. I need $300 plus shipping for the bags and plates and $250 for the brakes. I am willing to trade for drop spindles, 2/6 springs or impala disk brake parts.

11-13-2011, 09:46 PM	#1
blazerboy72 Senior Member Join Date: Mar 2002 Location: Temple, Ga Posts: 854	Bags, plates and camaro disks Plans for my project has changed again. I have decided to go with a static drop, so I have 4-re7 bags front plates and cut cups with several fittings and some line. I also have decided I dont want e-brakes. I have a complete camaro disk brake setup i wont be using. It includes used calipers with cables glocks brackets, new pads and rotors. Non off these parts have any miles on them other than the calipers but they have been installed just sitting there so they may have surface rust but I can blast them if needed. Everything is still installed, I am going to try to pull it out this week. I need $300 plus shipping for the bags and plates and $250 for the brakes. I am willing to trade for drop spindles, 2/6 springs or impala disk brake parts. Last edited by blazerboy72; 11-14-2011 at 06:31 AM.