|
Re: 4 link ?
Quote:
Originally Posted by fuzzy1nickels
I am getting ready to set up my 4-bar as well. I had a question on the fabrication side of it though. Do I need to pull my axles before welding on the axle tubes? or is it common practice to burn in brackets with the axle and fluids still in the housing?
|
This is one of those things where if you ask 6 different people, you'll get 6 different answers (opinions). You can definitely weld w/the axles in place & the housing full off lube.
I would make sure to minimize heat soak & change the fluid when your done for sure.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|