|
Re: need all the advice in can get
Quote:
Originally Posted by pale-rider
yup that would be the setup i was looking at lol any pics of how the lower shock mounts are dont that is the only factor i have left i looked at that link you posted SCOTI and im sure those will work just wanna covert all my bases and i like to see pics so i know exactly what i need to do... Thank you
|
On that particular set-up, I remember them using the factory lower shock mounts. On the pass side, they just cut it off & swapped it so the shock would mount to the back side of the rear-end housing vs the front. They then attached the shock stud to the frame in the same area as was done on the driver side.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|