The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - not new to the board or trucks.But new to 4wd

c-tenkid · 11-29-2011, 07:45 PM

Thanks for the replies guys.The problem I am having is the driver side rear cab corner is about 2 inches lower than the bed.The passenger side is fine.But the driver side is outta wack.

I looked on ECE's website and noticed that there is a 4wd body mount set and 2wd.As well as differences between 1/2 ton and 3/4 ton.
I am going to call ECE this week and talk to them about it.the

Nothing on the frame appears bent or tweaked.And the body I took off sat well on the frame.

By the time I get home from work I got about a half hour before its dark and the truck is outside.So not alot of time to work on it during the week.

Thanks again for the help.Hopefully there is a simply solution!

11-29-2011, 07:45 PM	#5
c-tenkid Registered User Join Date: Apr 2003 Location: Festus mo Posts: 370	Re: not new to the board or trucks.But new to 4wd Thanks for the replies guys.The problem I am having is the driver side rear cab corner is about 2 inches lower than the bed.The passenger side is fine.But the driver side is outta wack. I looked on ECE's website and noticed that there is a 4wd body mount set and 2wd.As well as differences between 1/2 ton and 3/4 ton. I am going to call ECE this week and talk to them about it.the Nothing on the frame appears bent or tweaked.And the body I took off sat well on the frame. By the time I get home from work I got about a half hour before its dark and the truck is outside.So not alot of time to work on it during the week. Thanks again for the help.Hopefully there is a simply solution! __________________ 69 c-10 lwb,Converted to 4x4,dana 44f,12blt,4 inch lift,vortec headed 355,th350/np203 34x10.50x15 swamper tsl's