|
Re: Big Red, my 68 3/4 ton GMC
So the bed is cut in two, but now I need to get out the scrap sections. Here it is after a little more cutting:
Driver's side
Passenger's side
After I cut the bed floor 12" shorter with a skill saw I did a test fitting and this is how it looked:
I was happy with how it lined up, so I decided to use the scrap pieces to practice my welding. Here is what the test welds looked like
After grinding
Next up, fitting and welding...
__________________
68 3/4 ton  (Project)-350 Small Block, .030 over, 10:1 comp, 3998993 heads, C3BX edelbrock intake, comp cams XE268, Holley 670 SA, long tube headers, dual flow 40's, E-fan, Alum rad, currently under the knife getting shortened and bagged  build thread
41 3/4 ton (wife's)-flatbed, fully restored to original
01 Tahoe LT 4WD (my daily driver)-Magnaflow Muffler, Rollin on 22's
02 Ford Mustang Convertable (Wife's Car)-Flowmaster 50, Clear corners, Intake, sittin on 18's
|