The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

snacks · 12-13-2011, 01:24 AM

it should start on the cross shaft first,,both sides and then it will go into the controll arm on its own. you should be able to thread each end cap onto the center cross shaft and as you tighten them they make there way into the ends of the controll arm, make sure you have the correct cross shaft

12-13-2011, 01:24 AM	#4
snacks Registered User Join Date: Jan 2009 Location: rocklin california Posts: 142	Re: Lower control arm issue it should start on the cross shaft first,,both sides and then it will go into the controll arm on its own. you should be able to thread each end cap onto the center cross shaft and as you tighten them they make there way into the ends of the controll arm, make sure you have the correct cross shaft