The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

2tankin79 · 08-29-2003, 04:22 PM

I didn't even think about the heater core, that would be a real pain to work on. i was thinkin takin some sheet metal, take the original glove box and form the sheetmetal over the glovebox, but just a lil bigger size (size needed to fill hole) weld it up there, and grind it all out.
I was also thinkin while i'm at it, i might as well shave the ash tray door as well, i dont use either of these, seein as how i have ''custom seats'' in my truck which have TONS and TONS of storage space.

thanks, Jeff

08-29-2003, 04:22 PM	#5
2tankin79 Registered User Join Date: May 2003 Location: indiana Posts: 288	I didn't even think about the heater core, that would be a real pain to work on. i was thinkin takin some sheet metal, take the original glove box and form the sheetmetal over the glovebox, but just a lil bigger size (size needed to fill hole) weld it up there, and grind it all out. I was also thinkin while i'm at it, i might as well shave the ash tray door as well, i dont use either of these, seein as how i have ''custom seats'' in my truck which have TONS and TONS of storage space. thanks, Jeff Last edited by 2tankin79; 08-29-2003 at 05:33 PM.