Quote:
Originally Posted by VeronikA
How big are those drawings?
|
Thanks for the kind words, the sizes are vaired.
#1 a bladed heart = is the size of normal piece of copy paper
#2 Darkness from the old Tom Cruise/Tim Curry movie "Legend" AND
#3 a scene from a story a world I created when I was 14 years old = is half poster size
#4 a study in armor detail on a medusa themed monster = copy paper sized
#5 a rose I did with felt pens... = Greeting Card size
Decided that -23* was just too chilly to spend too much time at the junk yard this morning, I am trying to get the headlight buckets cut out of a donor core support for my pop up lights project.
Got both sides 75% cut before my batteries pooped out on me, and my toes and fingers were starting to protest.
So I came home and started in on my cab corner.
#1 is my donor section and my problem area.
#2 I started with cutting out the spot welds along the door jamb.
#3 Then I taped off and cut out the minimum of the problem area.
#4 I used the cut out problem area as a template, then holding the donor section up to the cab, I traced my cut lines again from the inside of the cab in a different color, and over size cut my patch. Then I slowly and incrementally trimmed the patch and the cab until the two fit up nice enough for me to start worrying about over doing it.
#5 I think as I tack weld it in I will be able to get that gap closed even more that it is showing in the pic. I only had a couple of vice-clamps holding it in place for photos.
Am done for the day, wife has dinner ready and I deserve some serious beers!
Check you all tomorrow!!!