Quote:
Originally Posted by wutnxt
Well i fired up the engine in the new chassis and it really runs.....it really does....Just about everything that could have been wrong was wrong, the rocker studs were lose so had to strip all of the roller gear off and tighten all the studs down. Then had to set the roller rockers.......drove the oil pump with a drill until I had lots of oil pressure then set the distributor back excatly where it was.....then just before i tried to start it i found out it was 80 degrees out......( after i buttoned up everything with out checking anything )
Those aluminum angle plug heads hated every type of exhaust I tried....long tube headers.....fenderwell headers....it's impossible to pull atleast have the plugs with the exhaust on. I broke a couple of plugs as it was trying to get the rest out.
Note to self : Never rush and assume that the guy who did the job ahead of you did it right the first time.
|
Have you tried some short spark plugs not sure of the brand I had to use them in my race truck.