View Single Post
Old 01-19-2012, 03:56 PM   #4
Pro Performance
Registered User
 
Pro Performance's Avatar
 
Join Date: Aug 2010
Location: AZ
Posts: 3,069
Re: Bagged trucks with NO dropmember or Z'd frame

The ones on there now are about 28.8" all around. The wheels / tires I am getting from Jon @ Driverz will be 27" up front and 28.6" in the rear.

Right now I have leafs in the back, but I will be switching to 4-link soon. Should have just done it from the start. The only thing, is the axle center section will hit the bed floor. So, if I were to notch (which I won't), I would get about an inch more drop. But, with the way it sits, I don't need to go lower in the rear, cause the front won't go any more to match.

I think my pinch weld is 3-4" off the ground. I will re-measure tonight when I get home.
Pro Performance is offline   Reply With Quote