The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

blkcorvair · 01-24-2012, 11:30 AM

MBGMIKE from here on the forums is sending a few for me to try. I did finish assembling the Drivers Sde Last Night. The small rivets dont hold the frame to the division bar very tightly. So I used Stainless Pop rivets there and they hold very well. I did use the original type rivets in the Rubber strip. I also cleaned out all the old felt in the division bar and replaced with some from GMC Pauls. Fit and looks very well. I did not rivet tha in. Just used some 3M Super weather strip adhesive.

01-24-2012, 11:30 AM	#3
blkcorvair Registered User Join Date: May 2011 Location: Long Island NY Posts: 795	Re: Vent window refurbishing review MBGMIKE from here on the forums is sending a few for me to try. I did finish assembling the Drivers Sde Last Night. The small rivets dont hold the frame to the division bar very tightly. So I used Stainless Pop rivets there and they hold very well. I did use the original type rivets in the Rubber strip. I also cleaned out all the old felt in the division bar and replaced with some from GMC Pauls. Fit and looks very well. I did not rivet tha in. Just used some 3M Super weather strip adhesive.