The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Hugger_Orange · 01-26-2012, 04:08 PM

The spring is there... it's just hard to see in that pic.

Good to know about the nut. It was considerably more loose than your recommendation and it still held the shifting rod but I have tightened it up snug.

I have a TH350 so that explains the bend. You are full of useful information!

I just joined 67-72chevy forum yesterday and I'm loving it. One problem posed, one problem solved. Two questions posed, two question solved and last but not least, one problem I didn't know I had, one problem I didn't know I had now solved.... all in the same thread. Nice.

Thanks again.

01-26-2012, 04:08 PM	#27
Hugger_Orange Registered User Join Date: Jan 2012 Location: Pearland, TX Posts: 4	Re: Steering Column assistance needed The spring is there... it's just hard to see in that pic. Good to know about the nut. It was considerably more loose than your recommendation and it still held the shifting rod but I have tightened it up snug. I have a TH350 so that explains the bend. You are full of useful information! I just joined 67-72chevy forum yesterday and I'm loving it. One problem posed, one problem solved. Two questions posed, two question solved and last but not least, one problem I didn't know I had, one problem I didn't know I had now solved.... all in the same thread. Nice. Thanks again.