Quote:
Originally Posted by Eagle Custom
well I have made a little progress I found some good doors,fenders and 3" beltech spindles and 2.5" groundforce coils the coils are brand new. Problem is I was planning on dropping the front with the spindles and coils and doing a flip kit on the rear but after installing the drop on the front it looks like a flip will be to much. I have attached a pic what do you guys think.
|
Is there an engine and trans currently in it? If so it seems a little odd to me that it looks like it stock height, slightly loser in the front than the rear with 5.5" of drop kit installed up front. If not I would try and locate a engine/trans combo to set in it for a couple days to weight the front suspension down a little and see where it is sitting to decide whether or not the flip kit will be to much. If you have an engine and trans in there and you just want it leveled out, see if you can grab a pair of leafs from a 4wd and they'll give you 2" of drop without cutting anything under the rear floor like drop shackles.
Blazer is looking good.