View Single Post
Old 03-01-2012, 11:10 AM   #4
jaros44sr
Senior Member
 
jaros44sr's Avatar
 
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,843
Re: Are all utility buckets created equal??

No, all utility buckets are not the same, as Tim stated....panels seem to sit a bit flatter to the floorboards, no rake in the seat. Plus, those seat bottoms will only mount up to the correct seat tracks. Seems like the differance is in the height of the rear mount of the seat track. I was going to drill the rivets out and just change the rear mount, but the width of the mount in differant to the seat bottom....trucks versus panels

If you need pics or demensions for the truck utility seats, lmk, as i have them in my blazer/jimmy. Might even have some spare parts laying around since i ran into the same problem youre having

All utility seats mount to the floorboard with a -+ 15" ctc hole

Your pass. side looks to have the hinged mount to allow it to tilt forward
__________________
Semper Fi...Uncle Sam, you da man

All parts offered to help are free, unless otherwise noted

Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST

AS usual, off topic

They say your mind goes second, can't remember the first


Jim

Last edited by jaros44sr; 03-01-2012 at 11:26 AM.
jaros44sr is offline   Reply With Quote