|
Re: PO has me PO'd
Bearings in, weird on the wedge, never saw a bearing race installed like that...service manual says to run the nut down until all the space is taken up, then give it a 1/16 - 1/8 turn more. Make sure the streering shaft is straight, when you tighten the retaining nut
Finally, the tilt works....last part of the puzzle was to install the spring to control the return, just a phillips screw driver and alot of pressure
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
Last edited by jaros44sr; 03-05-2012 at 02:55 PM.
|