Its been a while since I did that swap......trying to streeech the memory! The bottom (rear i beleive ) didnt sit right on the crossmember.......I heated & dimpled a spot ea side on the crossmember, & the top laid flat on the top edge of the frame. I think i got 1 hole to line up on the top on ea side, & had to drill the rest. Just curious....how much spacer did you need to use? crazyL 
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
|