I had to go [advance] with this post. I did order the cd from amazon and it should be here in a week (thanks).
I got some piccies today. I am not too discouraged but I could get nothing done on my project today. Perhaps someone can give me some insight with what is going on here so I don't feel too much like a retard (no offense).
Regarding the front radiator mounts. The small squishy ones are what was mounting my rad bracket. So I don't know if the big ones are them, and if you look in the second picture, they don't even fit in the hole, do I' have to make the mounting hole wider with a drill? Should I just reuse my old mounts? Where do these bushings go?
(The center metal ring of bushing does not quite fit in the hole in the front bracket, it is 1/8 inch too big.)
Concerning the cab bushings, I can't quite see the diagram above as it is too small. How do these bushings go? If I place the larger bushing between the cab and bracket and the cup bushing under the bracket; the two bushings are stopped together by the center ring and the gap is too large at the bracket to cinch up the bushings together. Should I grind that metal ring down a bit to flush it up with the bracket so that the two bushing pieces squeeze together? (Sorry for this bs paragraph
How do they go? The cup up or the cup down?
Also, I don't know if I can piggyback another prblem unto this message but the new gas tank I bought just won't fit. Man oh man, here's some pics, what should I do? Cut the frame up? They spout doesn't even clear the side of the frame.
picture taken under the vehicle.
picture taken above the rear left wheel.
picture taken with tank removed and from under the bed.
Cheers,