The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

64shortbox · 03-26-2012, 10:20 AM

The shaft is from a 74 Chevy C10. If I remember correctly my column was a 3/4" X 36 Spline shaft & the stainless U Joint I got off eBay it's 3/4" X 36 spline one end & 3/4" Double D for the intermediate shaft end. When you get your intermediate shaft once you sit on the ground and smack it to break the plastic pins make sure you slide it up & down until it moves freely. It will help a LOT when you reassemble everything.

03-26-2012, 10:20 AM	#13
64shortbox Registered User Join Date: Jan 2011 Location: Tulare, CA Posts: 735	Re: Shortening my column question? The shaft is from a 74 Chevy C10. If I remember correctly my column was a 3/4" X 36 Spline shaft & the stainless U Joint I got off eBay it's 3/4" X 36 spline one end & 3/4" Double D for the intermediate shaft end. When you get your intermediate shaft once you sit on the ground and smack it to break the plastic pins make sure you slide it up & down until it moves freely. It will help a LOT when you reassemble everything.