The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

impalaboy9 · 04-11-2012, 07:15 PM

I have done some additional reading and determined that a PCV is a better way to go. I still have not been able to find the adapter pictured but have read of some guys putting a 1 1/4" PCV gromet into the block and running a 90* PCV valve and hose to the carb. This sounds cheap and easy but I'm concerned the block will get too hot and melt the grommet. Any thoughts?

04-11-2012, 07:15 PM	#17
impalaboy9 Registered User Join Date: Dec 2006 Location: lincoln ne Posts: 57	Re: What I have been up to lately I have done some additional reading and determined that a PCV is a better way to go. I still have not been able to find the adapter pictured but have read of some guys putting a 1 1/4" PCV gromet into the block and running a 90* PCV valve and hose to the carb. This sounds cheap and easy but I'm concerned the block will get too hot and melt the grommet. Any thoughts?