The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

84_chevy · 04-12-2012, 11:01 PM

I watched a vid on you tube of a guy changing the gasket but he had the motor out of the truck and upside down. I'm sure that's the easiest way to do the job but not very practical for me.

He used a 4 part gasket, the 2 rubber thingies that go over the crank shaft end a the 2 cork thingies that go along the oil pan sides. are you referring to the 2 rubber thingies or are there other gaskets deeper inside that I don't know about?

04-12-2012, 11:01 PM	#6
84_chevy Registered User Join Date: Aug 2009 Location: Toronto, Ontario Posts: 111	Re: 2 Questions I watched a vid on you tube of a guy changing the gasket but he had the motor out of the truck and upside down. I'm sure that's the easiest way to do the job but not very practical for me. He used a 4 part gasket, the 2 rubber thingies that go over the crank shaft end a the 2 cork thingies that go along the oil pan sides. are you referring to the 2 rubber thingies or are there other gaskets deeper inside that I don't know about?