View Single Post
Old 04-21-2012, 05:27 PM   #4
Doubletrouble
Registered User
 
Join Date: Jan 2012
Location: Flagstaff, AZ
Posts: 19
Re: HEI Installation

I've followed the yellow wire from the coil back to the starter and there was no external resistor. I then followed the purple wire back to the plug in at the firewall with again no external resistor. The purple wire is a #10, I believe and the yellow wire is much thinner. I am thinking that since the yellow wire is not #10, I need to replace it with a #10 so as to be consistent. I did meter the lines and I am reading 9 volts at both the coil and at the yellow wire connection at the solenoid. I do have 12 volts at the solenoid hot lead from the battery, as one would expect. I am still looking for an external ballast resistor...

Al
Attached Images
  

Last edited by Doubletrouble; 04-21-2012 at 05:46 PM. Reason: added metered readings
Doubletrouble is offline   Reply With Quote