The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

hartbraker · 05-09-2012, 03:22 PM

If there is any way to stick a tape measure through a hole in the rim I'd suggest that and measuring to check the width in comparison to another rim. Backspacing you can check from the back side of the rim. Measure the distance from where the rim is bolted to the hub to the inside lip of the rim (where the tire is seated on the bead). Then check that measurement in comparison to another rim... It's likely a backspacing difference, but I've been known to be wrong.

Good eye though catching the difference.

05-09-2012, 03:22 PM	#5
hartbraker Registered User Join Date: Apr 2011 Location: Centerburg, Ohio Posts: 172	Re: Tire Sticking Out If there is any way to stick a tape measure through a hole in the rim I'd suggest that and measuring to check the width in comparison to another rim. Backspacing you can check from the back side of the rim. Measure the distance from where the rim is bolted to the hub to the inside lip of the rim (where the tire is seated on the bead). Then check that measurement in comparison to another rim... It's likely a backspacing difference, but I've been known to be wrong. Good eye though catching the difference. __________________ 1986 Chevy Silverado k30: factory air, tilt wheel, 454cu 7.4L, Turbo 400, NP205, Corporate 14 bolt, Dana 60 front, 4.10 gears, SRW, long bed, standard cab... MY TRUE LOVE