View Single Post
Old 05-13-2012, 12:46 AM   #7
Frankasaurus
Registered User
 
Frankasaurus's Avatar
 
Join Date: Aug 2011
Location: Milwaukie, OR
Posts: 19
Re: Newbie with driveshaft question

Thanks guys, that is what I was looking for. Basically I should just have a brand new one-piece driveshaft mad and make sure I have plenty of clearance. How did you go about that? Put a lot of pressure on the rear frame to go as low as possible and remove whatever contacts the shaft, then raise the truck off the ground so the suspension is unloaded and do the same again? Or does someone have knowledge of the actual features to remove? I appreciate your advice, just want to do this right to begin with rather than find out on the road!
__________________
Frank Smith
------------------
'66 C10 Long Bed
350/350, Dropped
Frankasaurus is offline   Reply With Quote