The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Help with 3/4 ton rear hub/drum instalation?

Stricklinator · 05-13-2012, 01:18 PM

I had to completely rebuild my '69 C20's rear brakes. I am installing the hub/drum assembly and the manual says to torque the inner wheel bearing nut to 50-60 ft. Lbs and the outer to 170. The problem is that when I torque down the inner nut the hub/drum assembly no longer spins freely on the spindle. Is this correct? Should I loosen the inner nut to allow for free spinning movement or do I just follow the manual?

I am hoping to get wheels back on today, so any help is appreciated greatly!

Paul
Posted via Mobile Device
Posted via Mobile Device

05-13-2012, 01:18 PM	#1
Stricklinator Registered User Join Date: Feb 2011 Location: Murrieta, California Posts: 234	Help with 3/4 ton rear hub/drum instalation? I had to completely rebuild my '69 C20's rear brakes. I am installing the hub/drum assembly and the manual says to torque the inner wheel bearing nut to 50-60 ft. Lbs and the outer to 170. The problem is that when I torque down the inner nut the hub/drum assembly no longer spins freely on the spindle. Is this correct? Should I loosen the inner nut to allow for free spinning movement or do I just follow the manual? I am hoping to get wheels back on today, so any help is appreciated greatly! Paul Posted via Mobile Device Posted via Mobile Device __________________ 1969 C/20, 307, 4-speed, rusty with manual steering and brakes!