|
Re: Where to terminate ls harness to existing harness.
Without knowing what year harness you have, it's hard to know what we're dealing with. What does C1-B11 feed? I would try to use a similar wire from your truck to what the circuit is intended for. Not sure on the other circuits either, but grey sounds correct to the pump- just make sure it is the post relay feed- the switched line from the PCM will not have enough volts/amps to run the pump.
__________________
-Chris
Instagram _elgringoloco_
'70 Short-Wide How to: Ruin a perfectly good C10
‘70 Blazer ConversionHow To: Ruin a Perfectly Good 4wd
'72 Highlander How To: Ruin a Perfectly Good K/5 (SOLD)
'72 Blazer 2WD How to: Ruin a perfectly good Blazer (SOLD)
'05 Yukon Daily Driven (not so stock) Yukon (SOLD)
‘07 Yukon Denali (daily)
Members met list: SCOTI, darkhorse970, 67cheby, 67cheby'sGirl, klmore, porterbuilt, n2billet, Fastrucken, classicchev, Col Clank, GSFMECH, HuggerCST, Spray-Bomb, BACKYARD88, 5150, fine69, fatbass, smbrouss70, 65StreetCruiser, GAc10boy
|