[67c10rustbuket]

Then I bolted the pillar to the cab support through the inner rocker/floor. I will put a few welds on it once I set the door gap. Another test fit of the rocker and the rocker seems to fit very well so far but I will wait on another test fit of the door to make that call. with my old cab corner held in place all the gaps look nice though.

I haven't cut the replacement cab corner yet so I will see how that goes and make a choice there. You can see how my cab is about a half inch lower than the bed here (shot cab mounts) and that is what's holding me back on bolting in the trans mount and making any progress with the drivetrain. I will be addressing that and working on firing up the engine once I get some rollers on the front. Well and buying/making an exhaust system.. Later, Dan